Five Cognitive Misunderstandings of Intelligent Artificial Climate Incubator

Five Cognitive Misunderstandings of Intelligent Artificial Climate Incubator

The seed germination rate is one of the important indicators to determine the quality of seed. Germination requires sufficient water, suitable temperature and light. In order to meet the appropriate conditions for seed germination and to obtain correct and reliable germination test results, it is necessary to have advanced and basic germination test equipment - intelligent artificial climate incubators. Here's a look at the cognitive adjustments when using an intelligent artificial climate incubator:

First, although it is possible to arbitrarily set the operating time, temperature, humidity, and illumination values ​​for each test section. However, the temperature difference of each layer in the box is still there, the temperature inside and outside the same layer is also different, and the temperature difference between the inside and outside of the upper and lower surfaces of the incubator above the larger volume is greater, so I hope to pay special attention to this when using it. problem.

Second, from the measurement results, the temperature of the top layer of the intelligent artificial climate incubator is not the highest, and the temperature in the middle of the cabinet is the highest.

Third, the actual temperature in the intelligent artificial climate incubator is still somewhat different from the temperature of the tank. The general situation in the body is higher than the temperature set outside the tank, mainly because of the plant's respiration and photosynthesis.

Fourth, when using an intelligent artificial climate incubator, it is necessary to base the measurement on the number of germinating seeds correspondingly, not necessarily the bigger the better.

Fifth, when the number of samples is more than one grade, there are many times when the sample is to be controlled, the germination temperature should be high at the high temperature, and the low temperature should be at the low position so that all the samples can be synchronized.