In recent years, we have seen the rapid development of science and technology in our great motherland. This made me feel extremely proud for me as a Chinese. With the advancement of technology and the progress of people, we will join the Chinese cutting machine trading network to make progress together. Join the hotline, we look forward to your call. Details:/
Causes and solutions:
1) The loosening of the key connection between the gear and the shaft in the table. Can be re-keyed and firmly fixed.
2) The X-axis guide and the y-axis guide are not perpendicular. The magnetic table seat can be used with a dial gauge to adjust the verticality of the X and Y axis guides.
3) The X, Y axis drive belt is loose. Tighten the belt screw to tighten it.
4) The gap between the slider and the guide rail is too large. Replaceable sliders.
5) The tooth belt is too loose, creating a backlash. Tighten the toothed belt.
Tips:
The combination of laser technology and computer technology has enabled the rapid development of laser cutting technology. Correct use of laser cutting machines and the timely resolution of problems in use are very necessary. Laser cutting equipment usually needs maintenance, to do the following work:
(1) Regularly perform quantitative cleaning every day to remove debris on the table top, stopper and guide rail, and spray lubricant on the guide rails.
(2) It is necessary to remove the waste in the workpiece collection box at regular intervals so as to prevent the waste from blocking the exhaust outlet.
(3) Clean the cooling system once every two weeks and drain the machine. Refill with purified water (preferably distilled water) as the water will affect the light effect.
(4) 45 ° mirror and focusing lens should be cleaned with a special cleaning solution once a day, scrub with a cotton swab or cotton swab holding the cleaning solution from the center of the focusing lens to the edge of counterclockwise scrub, and should be careful to prevent scratches lens.
(5) The indoor environment will have an impact on the life of the machine, especially in wet and dusty environments. The humid environment makes it easy to make the reflective lens rust, but also easily cause a short circuit or laser discharge spark.
Editing: kunshanwl
Cixi Air-Fluid Brass Pipe Fittings with Nickel-Plated ,Max. pressure: 1200 psi, except Domestic Brass fittings Temp. range: -65° to 250°F,NPT connections. For use in water, oil, natural gas, and steam applications.
The Configurations as below:
Brass Pipe Hex Nipple,Brass Pipe Nipple,Male Pipe to Female Pipe Hex Bushing,Brass Female Pipe Coupling,Reducer Bushing ,Countersink Plug,Brass Female Pipe Tee,Brass Male Pipe Tee ,Brass Male Pipe to Female Pipe Elbow,Brass Male Pipe to Male Pipe Elbow,Brass MNPT Reducing Bushing,Reducer Bushing,Bushing,Brass Pipe Female Elbow 90 Degrees,Reducing Adapter,Male Elbow, 90 Degrees,Brass MNPT x FNPT Reducing Bushing,Brass MNPT x FNPT Street Elbow, 90 Degrees,Brass Female Pipe Tee.
Brass Pipe Thread Fittings, Brass Pipe Fittings, Threaded Pipe Fittings
Ningbo Air-Fluid Pneumatic Components Co., Ltd , http://www.air-fittings.com