The daily maintenance and maintenance of XCMG Chusheng Sprinkler needs to do the following:
1, according to coating requirements, before the new product, the tank should be filled with water to soak exhausted five days, and then the coating surface is rinsed with water, then filled with the water to stand for two days, water was let go to dress Drinking water.
2. Regularly inspect the seals of parts, switches, and suction hoses of the waterway system. If any leakage is found, the seals should be repaired or replaced immediately.
3. Regularly check the fixed conditions of the water tank, pump frame and bracket. All nuts should be tightened to ensure firm and reliable connection.
4, frequently check the pump and the power take-coupling, the coupling should be reliable, in normal operation, if found use PTO oil tank and a water pump shaft, the seal should be replaced
5. There is no anti-freezing device for the vehicle waterway system. Therefore, in cold regions, after the temperature is below zero degrees Celsius, the water in the water pump, water tank and waterway system should be immediately put on the net. Note that the water pump drain plug should be closed tightly after it is drained. Make sure to seal, otherwise it will affect the water pump.
6. The paint on the tank must not be stained with gasoline and kerosene, as this will accelerate the paint damage. Check the quality of the paint on the cans on schedule. When the paint is seriously damaged, paint should be applied immediately to prevent the cans from being rusted.
7. The use and maintenance of automobile chassis and engine parts are detailed in the instruction manual for trucks.
8, through the medium of the ball should not be too dirty to avoid scratching the sealing ring, the ball valve to reduce service life, not long in each work the ball half-open state, or easy to deform the seal ring.
9. The pump inlet filter should be frequently washed and disassembled to prevent the dregs from clogging the filter screen and affecting the flow.
10. Due to the wooden mat or rubber pad between the tank body and the automobile girder , the U -bolts of the U -bolts will loosen due to the deformation of the wood glue after loading . Therefore, the U -bolt must be tightened regularly after the vehicle is heavily loaded . It must be done when the new car is used.
For more information on the maintenance and product information of sprinkler products, please login or send to us.
Fork Lift Parts,Used Forklift Forks,Hydraulic Lifting Fork,Pallet Fork
Hydraulic Breaker, Hydraulic Grapple Co., Ltd. , http://www.nbhydraulicbreaker.com