The main causes of fire in the electrical circuit are: short-circuit of the circuit; bad contact; overload of the circuit; leakage of the circuit; spark and arc; and fire of the cable. Measures to prevent the electric circuit from catching fire:
1. The installation of electrical lines must be strictly in accordance with the electrical installation regulations. A special electrician is required to lay the lines.
2. Select the correct electrical circuit. According to the actual needs in the work life, the possible load can be selected with appropriate specifications of the electric circuit, and no fine or inferior electric wires should be used in order to reduce the cost.
3, the safe use of electrical lines. The installed electrical lines must not be pulled, connected, or added in any way to increase the electrical load of the entire line. Pay attention to understand the maximum load of the circuit used, and you must not exceed this limit during use, otherwise it may cause accidents.
4, always check the electrical line. Found that the insulation layer is damaged, it must be repaired. The service life of electric wires is usually 10 to 20 years. If overage is found, it must be replaced in time.
1. The installation of electrical lines must be strictly in accordance with the electrical installation regulations. A special electrician is required to lay the lines.
2. Select the correct electrical circuit. According to the actual needs in the work life, the possible load can be selected with appropriate specifications of the electric circuit, and no fine or inferior electric wires should be used in order to reduce the cost.
3, the safe use of electrical lines. The installed electrical lines must not be pulled, connected, or added in any way to increase the electrical load of the entire line. Pay attention to understand the maximum load of the circuit used, and you must not exceed this limit during use, otherwise it may cause accidents.
4, always check the electrical line. Found that the insulation layer is damaged, it must be repaired. The service life of electric wires is usually 10 to 20 years. If overage is found, it must be replaced in time.
Terex shock absorber (in reality, a shock "damper or coupling") is a mechanical or hydraulic device designed to absorb and damp shock impulses. It does this by converting the kinetic energy of the shock into another form of energy (typically heat) which is then dissipated. Most shock absorbers are a form of dashpot.
Our hot Terex shock absorber including Terex tr100 rubber shock absorber15228210;Terex tr50 shock absorber20020410;Terex3305/3307 damer assy15021228;Terex3307 rubber shock absorber15248885 etc.
Terex Shaft Coupling,Terex Flywheel Couping ,Terex Damper,Terex Shock Absorber
Chengdu Svoda Machinery Equipment Co.,Ltd , https://www.svdequip.com