How to remove the jaw crusher?

The most frequent repair item for a jaw crusher is to replace the thrust plate. For the entire link is to remove the crusher thrust plate, baffle screw must be screwed out Gui, lubricating cutting oil dry tube, the thrust plate is hung from the crane lifting hook or other lifting devices, then only the loose Open the spring at one end of the horizontal pull rod to resist the fixed jaw and remove the thrust plate. If the rear thrust plate is to be removed, the connecting rod should be pulled apart from the front thrust plate and the moving jaw, and the rear thrust plate should be taken out.

After the thrust plate is removed, cut off the thin oil lubrication pipe and the cooling water pipe, support the bracket under the connecting rod, and then remove the connecting rod cover to lift the connecting rod;

The main shaft of the crusher should be removed together with the pulley and flywheel. Move the motor (along with the belt) along the slide rails as far as possible toward the crusher and remove the V-belt. Then lift the shaft with a crane.

In order to disassemble the moving boring, the dry oil lubricating oil pipe must be cut off, the tie rod should be disassembled, the bearing cap removed, and then the crane pulled out with a crane or other lifting equipment.

Protective Face Shield

[MATERIAL]PET, Water and dust resistant, disposable, easy to clean, protective cover can be cleaned with disinfectant, not wash in high temperature and high pressure.
[FACE PROTECT]This face shield is designed to protect your whole face from spray and splatter, droplet, dust, oil smoke and so on.
[WIDE APPLY]General protection, Suitable for home, shop or dental use, dust and splash proof.

[COMFORTABLE ]The surface contacts with the skin has a soft sponge, the rope is elastic and comfortable to wear.

Protective Face Shield,Splash Face Shield,Safety Plastic Face Shield,Disposable Face Shields

Shenzhen Stardeal Industrial Co.,Ltd , https://www.szplasticblisterpack.com