Introduction: The continuous development of the times, people's demand for quality of life is getting higher and higher, thus driving the continuous innovation of the packaging industry. Take blister packaging as an example: due to the obviousness of the product after packaging, dust and ash prevention, it is well received by users. Favored, as the auxiliary equipment of the plastic packaging industry, high frequency machine can be seen everywhere, high frequency machine will inevitably appear some problems and problems in daily use, then, how to deal with these problems? Here's a brief introduction for everyone.
First, high-frequency plastic products are not ideal, may be: 1, high-week output is too large or too small, should adjust the coordinator, repeated testing, transferred to a qualified parameter. 2, welding time is too long or too short, should be based on different materials will weld the time relative to adjust or adjust the length of repeated trial and error. 3, the aging of the electron tube, should change a new electron tube to test. 4. If the temperature is too low or too high, check whether the thermostat and the heat pipe have been burned out or adjust the temperature relatively.
Second, the mold often jump sparks, may be: 1, the mold is uneven, the mold should be placed on the plate to see if the balance, and then repair the mold or replace the mold. 2, mold has impurities, air guns blow clean impurities. 3, high-week output is too large, should be adjusted to a suitable position. 4, the lower die or floor insulation material damage, should replace the new insulation material.
Third, the power indicator does not light, it may be: 1, the fuse blown machine, replace the fuse. 2. The power switch contacts are not connected. Use a universal meter to test whether they are connected. If they are not connected, they need to be replaced. 3, the indicator burned out, should replace the new indicator.
Fourth, no high-week output, may be: 1, the aging of the electronic tube or burn, should replace the new electronic tube test. 2. The contactor is bad. Replace it with a new contactor. 3, the resistance is bad, you should replace the new resistance test. 4. The rectifier is bad. Replace it with a new rectifier. 5, transformer is bad, should replace the new transformer test.
Fifth, the nose does not rise, it may be: 1, lack of air pressure, pressure should be increased. 2, valve failure, should replace the valve. 3, welding time relay failure, to meet the replacement time relay. 4, the cylinder is bad, should replace the new cylinder.
Six, plastic welding plastic rip when the crack, may be: 1, plastic material reasons, plastic material is too much impurities or replace the plastic material. 2, the machine power is not big enough, should be replaced by a relatively high power high frequency machine test. 3, high frequency processing is not enough, should be a relatively large increase in high weeks try it. 4, the temperature is not enough or too high, the temperature should be adjusted to the appropriate degree. 5, the mold did not do a good job, should repair the mold.
Seventh, the head does not fall, may be: 1, micro-switch failure, should replace the micro switch. 2, valve failure, should replace the valve. 3, delay time relay failure, should replace the time relay.
VIII. Sometimes there is no high frequency, but it may be: 1. The electronic tube is not completely bad, but it should be replaced with a new one. 2, the relay is loose, not inserted, should be removed and re-plugged. 3, the fan wind is not enough, should replace the new fan.
Trough Screw Conveyor,Shaftless Screw Feeder,Shaftless Screw Conveyor,Shaftless Spiral Conveyor
Quantum Conveying Systems Yangzhou Co.,Ltd. , https://www.quantum-sino.com