It belongs to the sanitation model. The operation of the road sweeper is as simple as a sprinkler, a sewage suction truck, and a suction truck. The production process of sprinklers, sewage suction trucks and suction trucks is simple and the operation process is relatively simple. The road sweeper production process is more complicated and the operation process is not so simple. There are many control switches on the road sweeper, and no one knows how to use it before training. The use of a sweeping vehicle in accordance with the regular steps can extend its useful life and reduce the number of parts to be replaced.
First, the preparatory work before sweeper sweeping:
1. Turn on the power of the power distribution box of the road sweeper and start the auxiliary machine.
2. Move the left and right pan control buttons of the sweeper to the lowered position, and then release the master switch.
3. Point the sucker's control button to the lowered position and return it.
4, open the sweeper spray switch.
5. Improve the speed of the secondary engine of the sweeper and drive the fan.
6. Control the speed of the sweeping vehicle according to the condition of the road surface. Do not drive too fast. A speed of around 10km/h can clean the floor without leaving any residue.
II. Precautions after cleaning:
1. Decrease the speed of the secondary engine of the sweeper to the idle condition.
2, turn off the water control switch.
3. Put the suction cup in place where the suction cup controls the switch to the rising position, and then return the control switch to the position.
4. Turn the switch control knob to the rising position, raise the swash plate, and then return the switch.
Third, dump the garbage steps:
1. After parking the sweeper, pull up the parking brake.
2. Start the secondary sweeper engine idle.
3. Turn the rear bin door switch of the bin to the open position.
4. Raise the litter box lift switch to a raised position and raise the litter box to discharge the litter.
5. After the garbage has spilled, return the bin.
6. Twist the rear bin door switch to the closed position and close the rear door.
7. Stop the slave engine of the sweeper and sweep the sweeper parts.
Tips: The above steps are only suitable for conventional sweepers. If sweepers are equipped with other configurations, do not follow this method. Operate strictly according to the manufacturer's requirements.
Large Diameter Seamless Steel Pipe
Large Diameter Seamless Steel Pipe,Seamless Steel Tubes,Large Diameter Steel Tubing,Large Diameter Seamless Pipe
Tianjin Gongjiantiangang Steel Pipe Co., Ltd. , https://www.gjalloytube.com