One. Routine maintenance and maintenance:
1. The dirt on the machine tool and the guide rail must be cleaned every working day to keep the bed clean. The air source and power supply should be turned off at work, and the remaining air in the machine belt should be drained.
2. If you leave the machine for a long time, turn off the power to prevent non-professional operation.
3. Observe whether there are any lubricants on the horizontal and vertical guide rails of the machine and the surface of the rack. Keep it well lubricated!
Two. Weekly maintenance and maintenance:
1. Clean the machine thoroughly every week, clean the horizontal and vertical guide rails, drive gear racks, and add lube oil.
2. Check whether the horizontal and vertical wiper works normally. If not, replace it in time.
3. Check that all torches are loose and clean the litter of the gun to keep the ignition normal.
4. If there is an automatic height-adjusting device, check whether it is sensitive and whether to replace the probe.
three. Monthly and Quarterly Maintenance:
1. Check the total air intake for garbage, and check whether the valves and pressure gauges are working properly. Check that the various gas pressures are within the allowable range. Relief valve maintenance, adjust the pressure reducer, the pressure gauge to the required pressure, the adjustment process should make the pressure from small to large, to ensure that the pressure regulator can be adjusted continuously. If it cannot be adjusted continuously or gas leaks from the safety valve, the new pressure reducer must be replaced. Replacing the components of the gas pressure reducer by yourself will cause damage to the equipment and even serious personal injury.
2. Inspect all tracheal joints for looseness and all tubes with no damage. Tighten or replace as necessary.
3. Before cutting, it is necessary to check whether the type of nozzle used is consistent with the gas used and the thickness of the steel plate to be cut. Do not use cutting tip beyond the range.
4. The cutting torch adopts a machine-made cutting torch produced by a professional manufacturer. The torch is used for a long time, the sealing surface is damaged, and the cutting nozzle is not tightly sealed. It must be replaced in time to ensure normal and safe use. 5. The tempering prevention device is an important component to ensure safety. , According to the requirements of the security department, it is strictly forbidden to remove the tempering preventer. Therefore, the flashback preventer uses gas resistance for a long time, can not guarantee the gas flow requirement or leak, and must be replaced in time to ensure the safe and safe use of the China cutting machine trading network, allowing you to buy the rest assured! A variety of CNC cutting machine and CNC cutting equipment, a variety of cutting machine models, let the optional! Official website: /
Schluter Deco,Decorative Moulding Profiles,Stainless Steel Decorative Profiles,Ss Decorative Profile
Foshan Knilex Aluminum Co., Ltd. , https://www.aluprofilemaker.com