Frequent fault treatment methods for precision salt spray test chambers In the harsh environment, long-term use of salt spray test chambers will inevitably lead to some minor faults. It is time-consuming and labor-intensive to find the repairs. In fact, some minor problems can be solved by themselves. That will definitely ask, we don't know how to deal with technology, don't worry, there are small series, today share some common faults and solutions so that everyone can solve problems easily.
1. After turning on the power, it can't operate normally. You can consider whether the water level in the heating water tank is too low. When the water level is too low, the equipment will cut off the power supply to ensure the safety of the equipment; If it is not working properly, it must be a functional failure of the salt spray test chamber equipment. At this time, you can contact the manufacturer for repair.
2. If the touch screen does not respond, we will check if the screen is automatically locked and unlocked. After eliminating the screen locking factor, please contact the manufacturer for repair or replacement.
3. If the water level in the salt spray test chamber is too low, we can check if the water level in the test chamber or saturated tank is sufficient.
4. When the temperature in the working chamber cannot rise to the set temperature, 1) we can check if the temperature of the test room temperature controller is too low; if so, just set the temperature controller to the required temperature; 2 Check if the safety protection switch setting is too low, as long as the safety protection switch is set to the required temperature; the cyclone test suggests that if the above two problems are eliminated, it still cannot be solved, it may be the heating system failure, the electromagnetic relay failure or Controller failure; need to find a manufacturer for repair.
5. If the spray is not timed, we immediately check if the temperature rises to the specified temperature, because if the temperature does not reach the preset temperature, the timing device must assume that the experiment has not started yet; of course, it may be because the set time and the spray time are the same, thus This prevents the timing time from being observed.
6. There is normal spray and the air compressor does not operate normally; under normal circumstances, for the safety of the equipment, the air compressor of the salt spray test box is generally equipped with an automatic protection system. When an abnormal use of the salt spray test box occurs, The air compressor automatically stops running, so when this type of fault occurs, you can use it as usual.
The above problems can be solved by customers themselves, but it should be known that “doing the bestâ€, if you can't understand the principle, you can consult the salt spray test box manufacturer to solve the problem. If you can't, you can let the manufacturer send technicians to the door for repair. Do not disassemble the equipment without authorization to avoid further malfunctions.
Sand Conveyor,Belt Conveyor,Grain Transmit Conveyor,Grain Conveyor Belt
Xinxiang Zhenying Mechanical Equipment Co., Ltd , https://www.beltconveyor.nl