How to use the engine of Ito gasoline generator set

The engine should avoid prolonged idle speed and operation below 50% of rated power, because the engine is idle for a long time or with low load, so that the fuel injected into the cylinder cannot be completely burned, which will cause carbon deposition, thus clogging the injector nozzle and the piston. Ring and may make the valve stuck. It also easily causes the turbocharger oil to leak into the compressor and cause the exhaust pipe to spray oil.

If the temperature of the engine coolant becomes too low, some unburned gasoline will dilute the oil on the cylinder walls and affect the quality of the lubricant in the crankcase to deteriorate, causing all moving parts in the generator to be affected by poor lubrication. . If the engine is not in use, stop it. Note: Any component failure, such as sudden increase in oil temperature due to increased load, sudden drop in oil pressure, abnormal sound, etc., should be immediately shut down for inspection.

The normal use of parking before the engine needs to idle for 3 to 5 minutes, so that lubricants and cooling water away from the combustion chamber, bearings and shafts and other parts of the heat, which is particularly important for turbocharged engines. In case of non-special circumstances, no sudden stop is allowed to prevent the supercharger bearing from being overheated due to supercharger overheating.

Always use the engine immediately after the stop to monitor whether there is a rubbing noise between the impeller and the housing of the turbocharger. If there is rubbing noise, remove the turbocharger and check by the professional to confirm whether the bearing clearance of the turbocharger is normal. Note: If the engine is operating in a cold climate, if no antifreeze is used, turn on all the drain switches on the engine after the shutdown is not working, and drain the cylinder block, cylinder head, water tank, cooling water in the oil cooler, and other devices. Cooling water inside the water-cooled attachment to prevent damage to the engine due to freezing.

The sealing of the engine's intake and exhaust lines must be maintained, while the performance of the gasoline engine will be affected. Always check if the nuts or bolts are loosened, if the pipe joints are tight, and if the gasket leaks. Note: When the gasoline engine is matched with the working machine, the load power should be matched properly. It is strictly forbidden that the load power is too large or too small. If the long-term overload operation is matched, the reliability of the gasoline engine will be reduced and the service life will be reduced; however, if the load power is too low, the long-term operation is required. Gasoline engine can not be fully used, but also easily lead to engine oil and a series of faults mentioned above.
 

Oil machine power output

Ito series gasoline engine output power from the flywheel end, and use the SAE interface to drive the working machinery, when used, it is forbidden to directly install the belt pulley at the flywheel end, drag the machine tool laterally, because this output power can easily cause the crankshaft and the main bearing to directly bear the lateral force and damage .

The front end of the crankshaft of the gasoline engine can output part of the power, and its maximum output power is not more than 50kW. However, at this time, driveshaft bearings, clutches, etc. should be installed between the front axle and the driven equipment. If it is a direct drag, it must not exceed llkW so as not to damage the main bearing and the transmission gear of the gasoline engine. For models with fans, it is never allowed to drive the machine directly by dragging it directly.

The user must take care that the gasoline engine is not allowed to start with a load. Therefore, a clutch device should be provided between the gasoline engine and a load device that cannot operate without its own load, and the gasoline engine should be started when the clutch is disengaged.

Related reading :

Shanghai Ito Power Co., Ltd. Main : Ito Gasoline Generator , Ito Diesel Generator , Ito Small Pump , Ito Digital Generator , Ito Electric Welding Machine